Skip to the content
Drive-Thru SOSGUIDE
All topics (2 of 13)
  1. 1What the board does
  2. 2Before you start
  3. 3Where to put the cameras
  4. 4Which lane type is mine?
  5. 5Set up the board
  6. 6Goals, the screen and alerts
  7. 7Using the board every day
  8. 8A TV with no PC: HDMI
  9. 9Reports
  10. 10Where alerts and reports go
  11. 11How the times are measured
  12. 12When something looks wrong
  13. 13Setup checklist

Drive-Thru SOS › Guide › Before you start

2Before you start

Ten minutes of checks here saves an hour of chasing wrong numbers later.

  • The cameras are on the gateway and play in Live View: one or more that see the drive-thru lane (section 3 shows where).
  • Each camera's second stream (sub stream) is set on the camera or recorder to H.264, up to 1280×720, 10 to 15 frames a second, at a sensible bit rate (about 0.5 to 1 Mbit/s). The gateway's AI watches this stream, and a starved one turns a distant car into a blur.
  • The gateway's clock and time zone are right (Settings › Date / Time). Dayparts, hours and reports use the store's time.
  • There is room for the cameras in the gateway's AI. Each drive-thru camera is analysed, like a camera with lines or areas. Settings › Analytics shows the AI capacity and how many more cameras fit.
  • You can sign in as an admin or a manager. They set up and change boards. Viewers only see the boards shown to them.
  • You know your lane: where cars line up, where they order, where they pay and pick up, and whether staff send cars to wait in a parking bay (section 4).
Good to knowThe board counts vehicles. People walking through the lane are not counted. A car that drives through a point without stopping (2 seconds or more) is not counted at that point either.

Stuck on a step?

iLink Professionals supports owners and installers. Call, or send us a message.